Rollz Motion Manual de usuario descargar pdf (Pagina 13)

Maintenance

Regular maintenance will increase the life and safety of your Rollz Motion. Rollz

International recommends maintenance takes place every two months.

Adjusting the brakes

While squeezing the hand brakes, the Rollz Motion should be unable to move.

After releasing the hand brakes, the Rollz Motion should be able to move

freely. Test the brake function before each use. If stopping performance is not

adequate, there are two ways to adjust the brakes. The adjustment screw by

the rear wheel is for basic or significant adjustment. The adjustment in Figure

12 beneath the locking knob at the end of the handlebar is for fine-tuning brake

performance. Make sure both the left and right side are adjusted properly.

1. Adjustment below (Figure 11)

Unscrew the locking bolt on the inside of the rear wheel. To tighten the brakes,

turn the adjusting screw clockwise (right). To loosen the brakes, turn the

adjusting screw counterclockwise (left).

2. Adjustment above (Figure 12)

Unscrew the locking disc just below the height adjustment knob / lever. To

tighten the brakes, turn the adjusting screw clockwise (right). To loosen the

brakes, turn the adjusting screw counterclockwise (left).

WARNING: Make sure the larger rear wheels do not turn while adjusting the

brakes. Both hand brake levers should be in the neutral position (not engaged or

locked) while adjusting the brakes.

WARNING: Stop using the Rollz Motion and contact your supplier if the brakes fail

to operate adequately after you have performed the above-mentioned steps.

Locking bolt

Adjusting

screw

below

Locking disc

Adjusting

screw

above

Figure 11

Figure 12

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Sin comentarios

Modele	Rodzaj dokumentu
SHM2	Instrukcja Obsługi Breville SHM2 mixer, 32 strony
STAND BEM800XL	Instrukcja Użytkownika Breville Customer Service Center, 64 strony

Rollz Motion Manual de usuario Pagina 13